Deep well pump TDP 5500 E
Powerful 1,100 W stainless steel pump (INOX) with a flow rate of up to 6,000 l/h
PUMPING SERVICE WATER TO WHEREVER IT CAN BE OF SERVICE
Become independent of the local water supplier and rising costs by using the high-quality deep well pump TDP 5500 E. For this much is certain: Tap water will always be more expensive. Reason enough to make use of alternatively available water sources such as rain or ground water to save money. With its 1,100 watts of power and a delivery head of 58 metres the slim deep well pump TDP 5500 E in stainless steel design transports up to 6,000 litres of service water per hour from wells, water reservoirs, rainwater cisterns or drainage shafts. Deep well pumps are specifically made for pumping water from great depths.
Independent thanks to natural resources
Utilize ground water that is available free of charge to water you garden or operate lawn sprinklers and other irrigation systems. The deep well pump can also be used as complementary measure for a more cost-effective domestic water supply. For example it can be used as alternative water source for the operation of your washing machine or to flush the toilet. Pumped, no-cost service water is not of inferior quality. The integrated dirt strainer of the deep well pump TDP 5500 E ensures clean water with filtered out dirt particles. On top of that, rainwater is softer and contains less lime than standard tap water which proves beneficial for washing machine and water-bearing lines and components in general.
ENVIRONMENTALLY SOUND AND BUDGET-FRIENDLY
Your decision to purchase a TDP 5500 E deep well pump is definitely the right choice and an investment in the future – not just in the light of global warming and climate change. Water is and will remain a valuable asset that should be treated responsibly and sparingly. Instead of using elaborately treated drinking water to wash your dishes and laundry or to water your plants you can make an active contribution to environmental protection by using rain, ground or service water.
Trotec's deep well pumps are highly efficient submersible pressure pumps which – due to their special design and high-quality technology – can be used in drilled wells with a minimum diameter of 11 centimetres. For the unproblematic water transport from great depths the standard equipment contains a connection cable of 23 metres length and suspension eyes for lowering the pump into wells, cisterns, drainage shafts or similar. Like all submersible pressure pumps our deep well pumps, too, are optionally suited for either fixed installation or the mobile application at various sites.
In the long run self-pumped water saves money. The investment for installing a well in your own garden (if not already present) will quickly redeem itself over the course of only a few years – depending on the individual usage intensity. Specialized well builders can help you in the planning and construction phase of your own garden well.
HIGH-QUALITY TECHNOLOGY, EXCELLENT WORKMANSHIP
A robust housing made of stainless steel protects the TÜV-tested, maintenance-free copper motor. High-end workmanship guarantees a smooth, long-lasting operation of the pump in continuous underwater application. Designed for year-round operation, the TDP 5500 E comes equipped with a stainless steel dirt strainer that provides protection against the contamination with particles to a size of 2.3 mm, a check valve with backflow preventer and a thermal protection circuit.
The 23 m underwater cable permits a convenient power supply and the external control box with on/off switch can be operated safely from a location that is far away from the pump's installation site. For lowering the pump into the water to be conveyed using a rope the pump housing has two practical suspension eyes located at the top of the device.
SUBMERSION DEPTH, DELIVERY HEAD AND FLOW RATE
With a high pressure of max. 5.8 bar, a maximum delivery head of 58 metres and a submersion depth of up to 20 metres the TDP 5500 E comes optimally prepared for pumping clear water from wells, shafts and other alternative water sources situated at great depth. Due to their compact diameter of only 100 mm the pump can be used in narrow bore hole diameters starting at 110 mm.
Better safe than sorry: dust- and water-proof
When water and electricity flow through a device at the same time, state-of-the-art protection measures are a must. With a deep well pump of the TDP series in watertight encapsulation you are always on the safe side. The deep well pump TDP 5500 E is dust- and water-proof as per protection type IP68. Accordingly, the pump can be left inside the well even during periods of non-use. Thanks to protection type IP44 the splash-proof control box can also be assembled in outdoor areas sheltered from the rain.
Finding a suitable deep well pump that meets your individual requirements
The water consumption of a lawn sprinkler depends on the hose diameter and the feed pump's water pressure.
Here is a rule of thumb for determining at least an approximate water demand: A customary lawn sprinkler needs roughly 800 to 1,200 litres of water per hour*
*depending on the water pressure
The further up the deep well pump has to transport the water, the lower will be the water pressure and the maximum flow rate in litres per hour. For this reason you should make sure the pump you choose is sufficiently dimensioned. Calculate the anticipated water demand and then decide in favour of the TDP deep well pump that best meets your individual requirements.
The deep well pump TDP 5500 E transports up to 6,000 litres per hour which – depending on the delivery head – is sufficient for the simultaneous water supply of several sprinklers.
If you want to make use of a smaller number of sprinklers, but they are located further away from the well, we recommend the deep well pump TDP 7500 E – it achieves a delivery head of up to 93 metres. With a flow rate of 4,800 litres per hour it also permits a sufficient pressure level for the parallel operation of several lawn sprinklers.
A suitable pump for any application scenario
Do you need a deep well pump for an even deeper well? If your answer is yes, we recommend the TDP 7500 E with a delivery head of 93 metres and a conveying capacity of 4,800 litres per hours. Depending on your individual requirements Trotec's submerged clear water pumps TWP 4005 E, TWP 7505 E and TWP 9005 E recommend themselves with a delivery head of up to 11.5 metres and flow rates ranging up to 14,000 litres per hour. With a delivery head of up to 11 metres and flow rates of up to 15,000 litres per hour the submerged waste water pumps TWP 4025 E, TWP 7025 E and TWP 11025 E from Trotec are also suitable for pumping contaminated water. With a delivery head of 42 metres and a flow rate of 3,300 litres per hour the garden pump TGP 1000 E comes optimally prepared for watering applications. Without difficulty the domestic water supply system TGP 1025 E can be integrated into an existing domestic supply network and reaches a delivery head of 30 metres as well as a flow rate of 3,300 litres per hour.
Special equipment features of the TDP 5500 E
A few practical benefits:
- Maintenance-free motor with integrated thermal protection circuit activated by overheating of the device
- Stainless steel dirt strainer
- IP68 type of protection for the pump – dust-proof and suitable for continuous underwater use
- IP44 type of protection for the control box – splash-proof
- External switchbox
- Reliable check valve preventing backflow of the conveyed medium
- 2 suspension eyes for lowering the pump into the well hole using a rope
- 23 m underwater cable
Best quality guarantee
With the TDP 5500 E you are always on the safe side, for this deep well pump is supplied in TÜV-tested quality, thus guaranteeing high value, safety and functionality.
Brand quality plus cost-efficiency
Reliable, powerful and suited for the most challenging fields of application:
these are some of the quality features of Trotec's deep well pumps. Thanks to their high capacity they are able to withstand the most extreme conditions. HighPerformance for demanding applications – after all, Trotec stands for brand quality and professional solutions with an excellent value-for-money ratio!
Die leistungsstarke Tiefbrunnenpumpe TDP 5500 E (IP68) aus Edelstahl fördert mit ihren 1.100 Watt bis zu 6.000 Liter Nutzwasser pro Stunde aus Brunnen, Wasserreservoirs, Regenwasserzisternen oder Drainage-Schächten.
Sie sparen: 90.00 €
249.95 € 159.95 € inkl. MwSt. Nettopreis exkl. MwSt. anzeigen
|Mains connection||220 - 240 V/50 Hz|
|Max. power input [W]||1,100|
|Pump capacity [W]||550|
|Cable length [m]||23|
|Max. conveying capacity [l/h]||6,000|
|Feed pressure [bar]||5.8|
|Grit of pump [mm]||2.3|
|Solids content in water [%]||0.25|
|Max. delivery head [m]||58|
|Number of phases||1|
|Max. water temperature [°C]||35|
|Max. submersion depth [m]||20|
|Minimum operating depth [mm]||783|
|Min. drill hole diameter [mm]||110|
|Ambient temperature - min. [°C]||0|
|Ambient temperature - max. [°C]||35|
|Type of protection||IP68|
|Connection plug||CEE 7/7|
|Cable length control box [m]||0.94|
|Protection type of the control box||IP44|
|Functions and features|
|Thermal overload protection|
|Thermal overload protection [° C]||100|
|Dry run protection|
|Stainless steel screws|
|Use of a suspension cord|
|Suitable for both permanent operation (>10h) or salt-water operation|
|Threaded connection||1 1/4"|
|Accessories scope of delivery|
|Suitable for hose (hose DN)|
|Suitable for thread|
|Tear-resistant nylon cord, 12 m|
|Length (packaging excluded) [mm]||100|
|Width (packaging excluded) [mm]||92|
|Height (packaging excluded) [mm]||783|
|(packaging excluded) [kg]||12.5|