Submerged clear water pump TWP 9005 E
  1. Products & Services
  2. Powertools
  3. Pumps
  4. Submerged pumps
  5. Submerged clear water pumps
  6. TWP 9005 E

Submerged clear water pump TWP 9005 E

900 W pump with near-ground suction for wipe-dry results with a flow rate of up to 14,000 l/h

Impressive 900 watts of power for pumping up to 14,000 litres per hour

Trotec's most powerful submerged clear water pump TWP 9005 E pumps off up to 14,000 litres of clear to slightly contaminated water per hour. This makes it the perfect partner if you suddenly need to pump large amounts of water off or over quickly and efficiently. It is excellently suited for draining water from pools, for the quick elimination of leakages caused by a defective washing machine or of ground water ingress in basement rooms as well as of water that has penetrated the walls owing to a flood or heavy rainfall. Another possible application would be when work is required in drainage shafts.

The maximum delivery head of the TWP 9005 E can amount up to 11.5 metres. An integrated check valve prevents the water from flowing back after switch-off and so reduces the time to restart suction.

With its high-performance and maintenance-free 900 W motor the TWP 9005 E pumps off even slightly contaminated water with particle sizes of up to 5 millimetres. With an enormous conveying capacity of up to 14,000 l/h the compact submerged pump renders good services in multiple scenarios and fast as the wind.

"Wipe-dry" with a residual water level of only 3 mm

On level ground, this high-performance unit with near-ground suction pumps off virtually all water leaving no more than a residual water level of 3 mm. The remaining water film can just be mopped up. Hence, the pump is ideally suited for drying shallowly flooded surfaces f.i. in basements or swimming pools quickly and thoroughly. A water level of only 80 mm is sufficient for the TWP 9005 E to start the pumping operation.

The clear water pump TWP 9005 E may be used in a water depth of up to 7 m – this is rendered possible by the robust, watertight and impact-resistant plastic housing. An integrated thermal protection circuit protects the submerged pump against overheating. Consequently, it is also optimally prepared for long-term applications. The high-quality ceramic face seal and a low-wear shaft render the TWP 9005 E particularly durable.

A reduced pump performance satisfies your requirements?

Depending on your individual requirements Trotec's submerged clear water pumps TWP 4005 E and TWP 7505 E recommend themselves with a maximum delivery head of 7.5 or 10 metres and a flow rate of up to 7,000 or 13,000 litres per hour.

Automatic switch-on and -off via float switch

Thanks to the steplessly lockable float switch the functioning of the electric pump is conceivably easy: simply set the desired water level and the automatic switch-on/switch-off function will see to the rest. The dry run protection protects the incorporated technology during automatic operation. Needless to say, manual operation is also possible at a low water level.

Via the float switch you can control the water level of the room or container to be drained. The pump switches on and off automatically according to the height of the float switch.

Practical universal connections

The comfortable carrying handle renders the transportation of the compact pump within the garden or to any other application site mere child's play. Simultaneously, it serves as pump suspension for the TWP 9005 E by use of the nylon cord (supplied in the scope of delivery), e.g. for lowering the pump safely into a pool. The device is equipped with universal connections at the elbow for inner diameters of 25 mm and 32 mm as well as 1'', 1¼'' and 1½''.

If required, further hoses can be connected to the pump via threaded connectors without difficulty. Due to the elbow's flexibly adjustable position hoses and pipelines may also run parallel to the ground. A wide operating range is ensured by the 10 m power cable.

Special equipment features of the TWP 9005 E

Particle size: 5 mm
The submerged clear water pump TWP 9005 E conveys clear or only slightly contaminated water with particle sizes of up to 5 millimetres.
Ceramic face seal
The high-quality ceramic face seal and a low-wear shaft extend the pump’s lifetime.
Integrated backflow preventer
The integrated backflow preventer (non-return valve) prevents the return flow of the water at the end of the pumping process.
Universal connections
Hoses and pipes with an inner diameter of 25 / 32 mm as well as 1’’ / 1¼’’ / 1½’’ threaded connectors can be flexibly coupled with the pump.
Steplessly adjustable float switch
The height for the pump’s automatic switch-on/-off can be reliably regulated by means of the steplessly adjustable float switch.
Near-ground suction during continuous operation to a residual water level of 3 mm
When locking the float switch in horizontal position, the pump operates continually and sucks off the water until the ground is “wipe-dry” (only 3 mm remain).
Ergonomic carrying handle
For lowering the pump into the water, the supplied 12 m nylon cord is affixed to the sturdy, ergonomic carrying handle.
Schematic overview
TWP 9005 E at one glance: Combined display of relevant performance values such as the switch-on/switch-off point, delivery head and submersion depth.

The TWP 9005 E is extremely versatile:

Suitable to an immersion depth of 7 metres
Up to an immersion depth of 7 metres, the pump is ideally suited for all applications in clear or only slightly contaminated and chlorinated water.
For use in slightly contaminated water as collected in rain barrels
With the submerged pump TWP 9005 E pumping off or recirculating the slightly contaminated water from cisterns or rain barrels can be accomplished in a trice.
Draining in the staircase to the basement
The basement steps have been flooded owing to heavy rain? If the water to be pumped off is only slightly contaminated, this does not constitute a problem for the clean water pump TWP 9005 E.
Application in basement laundry rooms
Used in swimming pools or basement laundry rooms – the submerged clear water pump TWP 9005 E with near-ground suction pumps level ground “wipe-dry”, i.e. to a residual water level of only 3 mm.
Technical data in comparison

All submerged pumps in direct comparison:

To find the submerged pump which exactly meets your requirements, please consult the concise overview of all submerged pumps from Trotec, which we're providing to you here so that you can compare them directly to each other.

Models which you do not wish to include in your comparison can be easily dismissed with only one click.

Technical data by comparison

A few practical benefits:

  • Impressive 900 watts of power for pumping up to 14,000 litres per hour
  • Maximum delivery head: 11.5 m
  • Ideally suited for the recirculation of water, for pumping it off or out of e.g. swimming pools, rain barrels, wells or basements after a flood, heavy rainfall and during work in drainage shafts
  • For effortless pumping of clear water with suspended particles sized up to 5 mm
  • Extremely durable due to ceramic face seal
  • Maintenance-free motor with integrated thermal protection circuit activated by overheating of the device
  • Automatic switch-on/-off due to steplessly adjustable float switch
  • Dry run protection during automatic operation
  • Fixing option for the float switch during automatic operation
  • Near-ground suction to a level of 3 mm resulting in a wipe-dry floor
  • IPX8 type of protection – protected against the ingress of water upon immersion
  • Universal connection for flexible coupling
  • Backflow preventer barring a return flow
  • Large ergonomic carrying handle – suitable for fastening the suspension cord
  • Submerged pump of TÜV-tested quality

All important features at a glance

Clean water
Powerful 900 W motor
Flow rate of 14,000 litres per hour
Delivery head of 11.5 metres
Immersion depth: 7 metres
A water level of no more than 80 mm is sufficient for starting the device
The device continues to operate to a residual water level of 3 mm
Slightly contaminated water with particle sizes of up to 5 millimetres
Universal connections for inner diameters of 25 mm and 32 mm
Threaded connectors of 1’’, 1¼’’ and 1½’’
Automatic device switch-on/-off
Manual continuous operation
Steplessly lockable float switch
Integrated backflow preventer
Sturdy, ergonomic carrying handle
Nylon lowering cable of 12 m length
Cable length: 10 metres
For the application in swimming pools
Use if a washing machine has sprung a leak
Scope of delivery for the submerged clear water pump TWP 9005 E

The submerged pump TWP 9005 E is supplied as complete set including reducer (with preassembled backflow preventer and seal ring), elbow, a nylon cord of 12 m length and a 10 m power cable.

Delivery head and flow rate

Delivery head and flow rate of the TWP 9005 E

With the TWP 9005 E you are always on the safe side, for this submerged clear water pump is supplied in TÜV-tested quality, thus guaranteeing high value, safety and functionality.

Brand quality plus cost-efficiency

Reliable, powerful and suited for the most diverse clear water applications: Those are some of the quality features of Trotec's submerged clear water pumps. No matter the demands, owing to their high capacity these pumps are never out of their depth. HighPerformance in every respect – after all, Trotec stands for brand quality and professional solutions with an excellent value-for-money ratio!

Tested for safety, TÜV GS ID 1419062842


Submerged Clear Water Pump TWP 9005 E show in Trotec online shop

Submerged Clear Water Pump TWP 9005 E

The compact submersible water pump TWP 9005 E impresses with its power and user-friendly handling both homeowners and passionate hobby gardeners. The max. Flow rate of 14,000 l / h speaks for the TWP 9005 E as well as the extraordinary head of 11.5 meters.

You save: 45 %

78.17 £ 42.84 £ incl. VAT Show net price (VAT not included)


Technical data

Technical data
General information
  Article number 4.610.000.009
Electrical values
  Mains connection 230 - 240 V/50 Hz
  Power input [kW] 0.9
Electric connection
  Connection plug CEE 7/4 (Schuko plug type F)
  Cable length [m] 10
Performance data
  Max. conveying capacity [l/h] 14,000
  Grit of pump [mm] 5
  Max. delivery head [m] 11.5
  Max. submersion depth [m] 7
  Minimum operating depth [mm] 80
  Max. water level after suction [mm] 3
  Max. water temperature [°C] 35
Safety feature
  Type of protection IPX8
  Protection class I
Functions and features
  On/off switch (float switch) Automatic
  Switch-on point float switch [mm] 600
  Switch-off point float switch [mm] 180
  Thermal overload protection
  Backflow preventer
  Stainless steel screws
  Suitable for both permanent operation (>10h) or salt-water operation
Housing design
  Stainless steel
Accessories scope of delivery
  Hose connection (inner diameter) 25 / 32 mm
  Threaded connection 1", 1 ¼", 1 ½"
  Backflow preventer
  Length (packaging excluded) [mm] 220
  Width (packaging excluded) [mm] 160
  Height (packaging excluded) [mm] 335
  (packaging excluded) [kg] 4.6

 standard equipment

 optionally available

 not available

Alternative products